MTD 111-070A - Manual (Page 15)

OFF-SEASON STORAGE HANDLE STORAGE
The following steps should be taken to prepare
lawn mower for storage.
1. Clean and lubricate mower thoroughly as
described in the lubrication instructions.
2. Refer to Engine Manual for correct engine
storage instructions.
3. Coat mower’s cutting blade with chassis
grease to prevent rusting.
4. Place blocks under deck to raise tires clear of
floor.
5. Store mower in a dry, clean area.
The handle may be placed in an upright position
for storage.
Move the hairpin cotters to the outer hole on weld
pins. See figure 8. Press inward on the bottom of
the lower handle and push forward. The handle
will lock in this position.
Reverse the above procedure to place the handle
in the operating position.
NOTE
The manufacturer DOES NOT recommend the use
of any accessory on this Rotary Mower other than
those manufactured by the mower manufacturer.
GRASS CATCHER Model No. 191-003A is available as optional equip­
ment for the mowers shown in this manual.
i
WARNING
t
2 .
1. The mower should not be operated without the entire grass catcher
or chute deflector in place.
The mower should not be operated without the protective shield on
the rear of the deck in place.
NOTE
Under normal usage bag material is subject to wear and should be
checked periodically. Be sure any replacement bag complies with the
mower manufacturer’s recommendations.
For replacement bags, use only factory authorized replacement bag No.
764-0176.
15