MTD 406 - Manual (Page 14)

Forward BeltKeoper
Drive Belt Pins
FIGURE 29.
NOTE: If the “V”-idler or flat idler pulleys are removed
for any reason, be sure to install with hub side against
the idler bracket. See figure 30.
Hub
OFF-SEASON STORAGE
If the tiller is to be inoperative for a period longer than
30 days, the following precautions are recommended.
1. Working outdoors, drain all fuel from the fuel tank.
Run the engine until it stops from lack of fuel.
A
WARNING: DO NOT DRAIN FUEL WHILE
SMOKING, OR IF NEAR AN OPEN FIRE.
2. Drain all the oil from the crankcase (this should
be done after the engine has been operated and
is still warm) and refill the crankcase with fresh
oil.
3. Protect the inside of the engine for storage as
instructed in the separate engine manual packed
with your unit.
4. Clean the exterior of engine and the entire tiller
thoroughly.
5. Wipe tines with oiled rag to prevent rust.
NOTE: When storing any type of power equipment in
an unventiiated or metal storage shed, care should be
taken to rustproof the equipment. Using a light oil or
silicone, coat the equipment, especially any springs,
bearings and cables.
6 . Store in a clean, dry area. Do not store next to
corrosive materials, such as fertilizer.
FIGURE 30.
14