MTD 195-746-000 - Manual (Page 8)

25. Move the lift lever on the tractor to the second
notch on the index bracket as shown in figure 16.
26. Thread the adjustment ferrule onto the lift rod
assembly until it lines up with the bottom hole in
the lift handle. Secure ferrule to lift handle using
flat washer (C) and hairpin cotter (J).See figure 16.
NOTE
This initial adjustment setting provides
a tilling depth of approximately 4".
Refer to Control section for
adjustment information.
27. Hook the short end of extension spring (A) to the
idler bracket support arm on the left side of unit.
Hook the longer end of spring to the hex bolt
on support pivot bracket which was assembled in
step 7. See figure 17.
DRIVE PULLEY
PULLEY ON TILLER
FIGURE 18
28. Assemble the belt as follows (refer to figure 18).
A. Belt is attached to the idler pulley assembly.
Back of the belt (flat side) goes against the
idler pulley.
B. Slip belt up and over pulley on tiller ( " V "
side of belt goes against the pulley).
C. Twist the belt 90° to the right as shown in
- figure 18. Slip the belt around the drive
pulley on the tractor.
NOTE
The tines on the tiller are designed to
rotate in the opposite direction of the
wheels on the tractor. If they rotate in
same direction as the wheels, the belt
is twisted in the wrong direction.
Unhook the belt from the drive pulley
and twist in the opposite direction.