MTD 195-746-000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
12.
Place carriage bracket assembly (R) in position
beneath the running board support rod on the
tractor. Secure each side of carriage bracket to
frame with hex bolts (E), lock washers (F) and
hex nuts (G). Tighten securely. See figure 7.
13. Remove the round belt guard from the idler on
tractor by removing the hairpin cotter. See figure
-
8
.
14.
Unscrew the "L" bolt and swing the wire belt
guard on the engine pulley forward. See figure 9.
FIGURE 9
This manual is related to the following products: