MTD 195-746-000 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
L'BOLT
VfIRE
EELT
CUARD
GUARD
II
HAIRPIN COTTER
FIGURE 10
IDLER PULLEY
15. Place the belt which is preassembled to the
carriage bracket assembly around the idler pulley
and engine pulley on the tractor. See figure 10.
16.
Reassemble the round belt guard and hairpin
cotter. Reassemble the wire belt guard and "L"
bolt. See figure 10.
3/4" WRENCH
COMPRESSION
SPRING (U)
LIFT RO D
ASSEMB :Y (W)
FLATWASHEI? (B)
HAIR PIN COTTER (J)
17. Place the large compression spring (U) over the
slotted end of lift rod assembly (W).
18. Place slotted end of lift rod (with spring attached)
over the rod on right hand side of tiller as shown
in figure 11. Secure with flat washer (B) and
hairpin cotter (J).
19. Using a 3/4" or adjustable wrench, tighten the hex
nut which is on the lift rod assembly until the
spring is compressed to 11" long. See figure 11.
FIGURE 11
FERRULE (P)
20.
Thread adjustment ferrule (P) on other end of
lift rod assembly a few turns. See figure 12.
FIGURE 12