MTD 195-746-000 - Manual (Page 3)

ASSEMBLY INSTRUCTIONS
FIGURE 1
NOTE
Right and left hand side of the unit
is determined from the driver's seat,
facing forward.
• Contents of Hardware Pack (See figure 1):
A
B
C
D
E
F
G
(
1
)
( 1 )
(
1
)
(
2
)
(4)
(4)
(4)
H (1)
I (1)
J (5)
M (1)
N (2)
O (3)
P (1)
Q (1)
Extension Spring
Flat Washer 1/2" I.D. x 1-1/2" O.D.
Flat Washer 5/8" I.D. x 1-1/4" O.D.
Flat Washers 1/2" I.D. x 1" O.D.
Hex Bolts 3/8-24 x 7/8" Long
Lock Washers 3/8" I.D.
Hex Nuts 3/8-24 Thread
Hex Bolt 5/16-24 x 1" Long
Spirol Pin
Hairpin Cotters
Hex Bolt 5/16-24 x 1-1/2" Long
Lock Washers 5/16" l;D.
Hex Nuts 5/16-24 Thread
Ferrule
Spacer 1/2" I.D. x 1" O.D. x 1/2" Long
-Loose Parts in Carton (See figure 2):
R (1) Carriage Bracket Assembly
S (1) Idler Bracket Support Arm Assembly
T (2) Support Pivot Brackets
U (1) Compression Spring
V (1) Idler Bracket Assembly
W (1) Lift Rod Assembly
FIGURE 2
1. Remove the cutting deck from your tractor if
one is attached.
2. Preassemble the idler bracket support arm (S) to
one support pivot bracket (T> and idler bracket
assembly as follows.
A. Place the idler bracket support arm through
the hole in support pivot bracket as shown in
figures 3 and 4.
FIGURE 3