MTD 195-746-000 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 13
21.
Place the tiller in position behind the tractor.
Slide the tiller forward so the lift rod assembly
and ferrule go through the slot in the right hand
fender on the tractor. See figure 13.
NOTE
On models prior to 1984, it is necessary
to
extend
the
slot in the fender
approximately
1-1/2"
further
down
toward the running board. The slot
should measure approximately 4-3/8".
SUPPORT
PIVOT BRACKET
22. There are two weld pins on the front of the tiller.
Push the tiller forward, then to the left so the
weld pins go through the bottom hole in the pivot
support brackets. See figures 14 and 15.
23. Secure the weld pin on the right hand side of
tiller using spacer (Q) and hairpin cotter (J). See
figure 14.
FIGURE 14
FLAT WASHER (D)
WELD PIN.
24. Secure the weld pin on the left hand side of
tiller using one flat washer (D) and hairpin.cotter
(J). See figure 15.
FIGURE 15