U”-channel bracket, Note, Handle assembly – MTD 219-320-000 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Hole Provied for

Tailpiece

“U”-Channel

Bracket

NOTE

Wheel hanger bracket must be removed
before the “U’’-channel can be pivoted
down.

Pivot the “U”-channel bracket down. Place the

—tailpiece in place in holes provided. See figure 4.

FIGURE 4.

3. Replace hex bolts in frame, which were removed

— in step 1. Tighten securely. See figure 5.

4. Remove hex bolts and belleville washers from front

of frame. See figure 5.

FIGURE 5.

Left Hand

Handle

e Hex Bolt

and Belleville

Washer

Hex Bolt (D)

Belleville Washer (E)

Lock Washer (F)

Hex Nut (G)

HANDLE ASSEMBLY

Place the right and left hand handles in place

------- against the tiller frame. See figure 6.

NOTE

The left hand handle has the clutch
grip preassembled. Refer to figure 1.

2. Start the hex bolt and belleville washer by hand

(removed in step 4) in the bottom hole in handle.

3. Secure the top hole in handle with hex bolt (D),

belleville washers (E), lock washer (F) and hex nut
(G). See figure 6.

FIGURE 6.