Note, Assembly instructions, Tools required – MTD 219-320-000 User Manual
Page 4: Parts in carton, Contents of hardware pack: (see figure 2), Tailpiece installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOTE
Reference to left or right side of the
tiller is determined from behind the
unit in the operating position.
Tailpiece
ASSEMBLY INSTRUCTIONS
NOTE
This unit is shipped WITHOUT GAS
OLINE or OIL. After assembly, see
separate engine manual for proper fuel
and engine oil recommendations.
Tools Required:
(2) Vz" Socket, Open or Box Wrench
(2) 9/16" Socket, Open or Box Wrench
Parts in Carton:
Tiller
-Handle Panel*
Depth Bar
Tailpiece
Handles*
Hardware Pack
FIGURE 1.
FIGURE 2.
Remove These
Bolts
Contents of Hardware Pack: (See Figure 2)
Carriage Bolts 5/16-18 x 1.75" Long*
Lock Washers 5/16" I.D.*
Hex Nuts 5/16-18 Thread*
Hex Bolts 3/8-16x1" Long
Belleville Washers
Lock Washers 3/8" l.D.
Hex Nuts 3/8-16 Thread
Clevis Pins
Hairpin Clip
Cable Ties
K (1) Self-Tapping Screw (Not Shown)
*May be preassembled on your unit.
Remove the tiller, all loose parts and literature from the
carton before discarding carton.
Extend the throttle control and place on the floor. Be
careful not to bend or kink control wire.
A (4)
B (4)
C (4)
D (2)
E (2)
F (2)
G (2)
H (1)
1 (1)
J (2)
K (1)
TAILPIECE INSTALLATION
1.
Remove two hex bolts located on the rear of tiller
------- frame. See figure 3. A 9/16" wrench is required.
FIGURE 3.