Assembly of engagement handle – MTD 24645-8 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. Thread hex nut (V) part way onto hex bolt (T).
Secure to pivot stand with hex lock nut (W) as
shown in figure 6.
Assemble the pivot stand to the pivot brackets
with two shoulder bolts (P), lock washers (Q)
and hex nuts (R).
Attach extension spring (Y) to long hex bolts on
tow hitch and pivot stand. See figure 6.
CONTROL
ENGAGEMENT
HANDLE
10
.
Find the center link of the tow hitch chain.
Place two flat washers (X) on hex bolt (J), then
the center link on chain and another flat washer
(X). Insert bolt down through the hole in the tow
hitch assembly which is nearest the wedge. Secure
with lock washer (G) and hex nut (H). See figure
7.
A .
I WARNING \
Exercise extreme caution when raising
and lowering the flip stand as it is
spring loaded and could cause personal
injury.
ASSEMBLY OF ENGAGEMENT HANDLE
1.
Place the flattened end of the engagement handle
down through the slotted bracket beside the beam.
Insert the end of the ferrule on the engagement
rod into the second hole from the end of the
engagement handle. See figure 8.
2.
Place shoulder bolt (L) through bottom hole in
engagement handle. Place rubber washer (M) on
shoulder bolt. Secure to bracket with hex lock nut
(N). Tighten lock nut until nut is flush with the
end of the shoulder bolt.