Trouble shooting chart – MTD 24645-8 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLE SHOOTING CHART
SYMPTOM
POSSIBLE CAUSE (S)
SOLUTION
Engine fails to start
A.
Check fuel tank for gas.
B.
Spark plug lead wire
disconnected.
C.
Faulty spark plug.
A.
Fill tank if empty.
B.
Connect lead wire.
C.
Clean, adjust gap or replace.
See engine manual.
2. Hard starting or loss of
power
A.
Spark plug wire loose.
B.
Dirty air cleaner.
A.
Connect and tighten spark plug wire.
B.
Clean air cleaner as described in
engine manual.
3. Engine overheats
A.
Carburetor not adjusted
properly.
B.
Air flow restricted.
C.
Engine oil level low.
A.
Adjust carburetor. See engine manual.
B.
Remove blower housing and clean as
described in the engine manual.
C.
Fill crankcase with the proper oil.
4. Will not split logs
A.
Reservoir fluid level low.
B.
Pump setting incorrect.
A.
Check and fill reservoir tank as
instructed in Operation Section.
B.
Adjust pump setting to 3,000 p.s.i.*
5. Leaking cylinder
A.
Broken seals.
B.
Scored cylinder.
A.
Replace seals.*
B.
Replace cylinder.*
NOTE: For repairs beyond minor adjustments, please contact your local service dealer.
^Should be performed by an authorized service dealer only.
15