MTD 110-329A - Manual (Page 8)

TO REMOVE GRASS
CATCHER
1. To remove the grass catcher, lift the rear of
grass catcher, push forward and unhook lock­
ing lever.
•2. Lift off grass catcher. See figure 13.
OPERATION
DO NOT OPERATE THIS
MOWER WITH THE CHUTE
DOOR OPEN, UNLESS THE
COMPLETE GRASSCATCHER
IS PROPERLY MOUNTED ON
THE MOWER.
NOTE
For shipping purposes your mower
is set with the wheels in a low cut­
ting height position. For best
results, raise the cutting position
until it is determined which height is
best for your lawn. See adjustment
section.
BEFORE STARTING
FIGURE 14.
Keep hands and feet away from the chute àrea on
cutting deck. See figure 14.
1. Check to see that the handle is in the
operating detent in the brackets on the deck,
and the upstop projections restrict the handle
from moving up and forward. If necessary,
remove the left side from the mounting pin on
the deck bracket. Push inward to decrease the
spacing between the two sides of the handle
until it is slightly less than the spacing of the
deck brackets. Reinstall over the mounting
pin and secure the hair cotter pin in the inner
holes.
2. Fill sump with oil, using a high quality
detergent oil classified “For Service SC, SD,
SE or MS.” Use SAE 30, SAE 10W-30 or SAE
10W-40 viscosity grade oil. Nothing should be
added to the recommended oil.
Place engine level. Remove oil fill plug. See figure
15.
Fill to point of overflowing. Pour slowly.
Capacity VA pints.