MTD 110-329A - Manual (Page 4)

ASSEMBLY
INSTRUCTIONS
Contents of Hardware Pack
A (2) Hand Knobs
B (2) Curved Carriage Bolts 5/16-18 X 1.75"
-C (1) Hex Bolt 1 / 4 - 20 x 1.50" Long
D (1) Hex Center Lock Nut 1 / 4-20 Thd.
E (2) Hairpin Cotters
F (2) Cable Ties
Long
FIGURE 1.
Lower
Handle
Handle
Mount
Bracket
Hairpin
FIGURE 2.
1. Remove the lawn mower, loose parts, hard­
ware pack and literature from the carton.
Make certain all parts and literature have been
removed before the carton is discarded.
2. Extend the throttle control which is attached
to the mower and place on the floor. Be
careful not to bend or kink control wire.
3. Place lower handle in position over weld pins
in handle mount brackets on deck. Secure by
placing two hairpin cotters (E) in inner hole on
weld pins. See figure 2.
NOTE
It may be necessary to bend the
ends of the lower handle inward
slightly to assure a snug fit against
the bracket mounting area.
Outer
Hole
(For Storage)
Inner
Hole
(For Operation)..
\
NOTE
■There are two ( 2 ) holes in the handle
mount brackets. Place hairpin cotter
in the inner hole for operation. The
outer hole is for storage. See figure
3.
FIGURES.