Curved carriage bolt (b), Upper- handle, Hand knob (a) – MTD 110-329A User Manual
Page 5: Lower handle, Note
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Curved
Carriage Bolt (B)
Upper-
Handle
Hand Knob (A)
■ Lower
Handle
4. There are two height positions for the handle.
Place upper handle in position over iower han
dle, selecting hole for either high or low posi
tion. Refer to figure 18.
— Secure with two curved carriage bolts (B) and
handle knobs (A) as shown in figure 4. The
knobs can be either to the inside or the out
side of the handle.
FIGURE 4.
5. Place the throttle control in position on the
left hand side of the upper han
dle. Secure with hex bolt (C) and hex lock nut
— (D) provided. See figure 5.
NOTE
Reference to ieft or right side of
machine is from operator’s position
at the handle facing forward.
FIGURES.
Cable
Tie (F)
6
. Secure throttle control cable to handle with
— cable ties (F) provided. See figure
6
.
7. Check all nuts and bolts for correct tightness.
FIGURES.