Assembly instructions, Unpacking, Parts in carton – MTD 24650-9 User Manual
Page 4: Contents of hardware pack (see figure 1), Chute deflector installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOTE
This
unit
is
shipped
WITHOUT
GASOLINE
or
OIL.
After
assembly,
see
separate
engine
manual
for
proper
fuel
and
engine
oil recommendations.
ASSEMBLY INSTRUCTIONS
Tools Required for Assembly:
(2)
7/16" Open End or Box Wrenches*
(1)
1/2" Socket Wrench
* An Adjustable Wrench may be used in place of one
of the wrenches.
NOTE
The right and left side of your shredder
is determined from behind the unit.
UNPACKING
Remove
the
shredder
and
loose
parts
from
the
carton.
Make
certain
ail
parts
and
literature
have
been
removed before the carton is discarded.
Parts in Carton:
Shredder
Chute Deflector
Hopper
Upper Leaf Ramp Section
Catcher Bag
Hardware Pack
Contents of Hardware Pack (See Figure 1):
Hex Bolts 1/4-20 x 1/2" Long
Hex Lock Nuts 1/4-20 Thread
Hex Washer Head Self-Tapping Screws
5/16-18 X 3/4" Long
Keepers
Safety Glasses (Not Shown)
A
(8)
B
(8)
C
(6)
D
(2)
(1) :
FIGURE 1.
CHUTE DEFLECTOR INSTALLATION
1.
Place
the
chute
deflector
in
position
on
the
discharge opening (on the left side of the shred-
------ der). See figure 2.
2.
Secure
chute
deflector
to
discharge
opening
with
hex bolts (A) and hex lock nuts (B). Heads of the
hex bolts are inside the discharge opening. Hex nuts
go on the outside.
3.
Tighten all four nuts and bolts securely.