Poulan 165370 - Manual (Page 6)

ASSEMBLY
snc
S RE
wrench
;izes arc
has been assembled i
nd proper operation of
as necessary to insure
rlltHlct* f? it
/ypfl n - I- — ^ u hi
3tioii of those parts left unassembled for shipping purpose
:d hardware you assembte must be tightened securely. Us
it tighines!
MBLY
r. Siandar
' 'il 1 ' ■'ti.rl ( T w, Ir vt .aerici Ut.liiy brill J
(1) 9/16" wrench Tire pressure gauge
( 2 ) 1 / 2 “ wrenches
I (in 1 » i(-fr ’land is mentioned in this manual, it
n the operating position (seated
ht hitid ihi iu'-iji o ^lieel).
fi'» liijvr ; HAL L jR FROM CARTON
f .^iiTON
ble ioose parts and parts cartons
iic f 1 1 ti . (be» p ige 5).
Ci iivOic |> I d boroiTi, along lines on all four corners
f i I il'iib .'tid lay panels flat.
» Check for any additional loose parts or cartons and
remove.
BEH iRt HOLLING TRACTOR OFF SKID
ATlAi T SiEERING WHEEL (See Fig. 1)
ASSEyOLE EXTENSION SHAFT AND BOOT
» Slide- eyfension shaft onto lower steering shaft. Align
mounting holes in extension and lower shafts and
instali S/l6 hex bolt and locknut Tighten securely.
IMPORTANT. TIGHTEN BOLT AND NUT SECURELY TO
18”22 Ff, LBS lORQUE.
• Piete tabs of steering boot over tab slots in dash and
push down to secure.
INSTAl I STFERING WHEEL
» Position Irani wheels of the tractor so they are pointing
siraijiit fonward.
» Cicc steering v/heel adapter onto steering shaft exten-
sicn,
• Frii.-itiuii stening wheel so cross bars are horizontal
(lefc to right) and slide inside boot and onto adapter.
• Assemble large flat washer, 3/8 lock washer, 3/8 hex
bolt and tighten securely.
• Snap steering wheel insert into center of steering
wheel.
• Remove protective materials from tractor hood and
grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES
IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR
IS TO ROLL OFF SKID.
TO ROLL TRACTOR OFF SKID (See Opera­
tion section for location and function of con-
trois)
» Press lift lever plunger and raise attachment lift lever to
its highest position.
® Release parking brake by depressing clutch/brake
pedal.
» Place freewheel control in freewheeling position to
disengage transmission (See “TO TRANSPORT” in
the Operation section of this manual).
® Roll tractor forward off skid.
• Remove banding holding discharge guard up against
tractor.