Poulan 165370 - Manual (Page 28)

problem 1 CAUSE RRECTION
Engine continues to run
when operator leaves seat
with attachfiient clutch
engaged
1. Faulty operator-safety presence controi system. 1, Check wiring, switches and connections. If not
corrected, contact an authorized service center/
department.
i'L.Of cut Ul'i'S'jfcfi 1 P/orri. bent or loose blade,
r,'io лег decK rot level
I ijuildui'i of glass ifc&ves, and bash under mower.
У Ber.t Ltade rnandrei,
I C iocjgej "ПОА'бг deck vent holes frorr; buildup of
ytas-', leaves, and irash around mandrels.
1. Replace blade. Tighten blade bolt.
2. Level mower deck.
3. Clean underside of mower housing.
4. Replace blade mandrel.
5. Clean around mandrels to open vent holes.
Mower siades wiii not I 1 Obstruction in ciulch mecnariisrn. 1, Remove obstruction.
rotate 1 2 Worrddamaged mower drive belt,
i 3 Гюгеп idler pulley,
1 4, Frozen blade mandrel. 2. Replace mower drive belt,
3. Replace idler pulley.
4. Replace blade mandrel.
Poor grass discharge 1. Engine speed too slow.
[ Travel .speed too fast,
3. Wet grass.
4. Mower deck not level.
5. Low/uneven tire air pressure.
6. Worn, bent or loose blade.
7. Buildup of grass, leaves and trash under mower.
8. Mower drive belt worn.
9. Blades improperly installed.
10. Improper blades used.
11. Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels.
1. Place throttle control in “FAST” position.
2. Shift to slower speed.
3. Allow grass to dry before mowing.
4. Level mower deck.
5. Check tires for proper air pressure.
6. Replace/sharpen blade. Tighten blade bolt.
7. Clean underside of mower housing.
8. Replace mower drive belt.
9. Reinstall blades sharp edge down.
10. Replace with blades listed in this manual.
11. Clean around mandrels to open vent holes.
Headlight(s) not working 1. Switch is “OFF”. 1. Turn switch “ON”.
{if so equipped) 2. Bulb(s) burned out.
3. Faulty light switch.
4. Loose or damaged wiring.
5. Blown fuse.
2. Replace bulb(s),
3. Check/replace light switch.
4. Check wiring and connections.
5. Replace fuse.
Battery will not charge 1. Bad battery cell(s).
2. Poor cable connections.
3. Faulty regulator (if so equipped).
4. Faulty alternator.
1, Replace battery.
2. Check/clean all connections.
3, Replace regulator,
4. Replace alternator.
Loss of drive 1. Freewheel control in “disengaged” position.
2. Motion drive belt worn, damaged, or broken.
3. Air trapped in transmission during shipment
or servicing.
1. Place freewheel control in “engaged" position.
2. Replace motion drive belt,
3. Purge transmission.
Engine “backfires”
when turning engine
“OFF”
1. Engine throttle control not set at “SLOW”
position for 30 seconds before stopping engine.
1, Move throttle control to “SLOW” position and allow
to idle for 30 seconds before stopping engine.
28