Poulan 165370 - Manual (Page 21)

BFiRv'ir r m i t M h i t i ' . i m i f н н ^
FRONT H i M»>#rH m T5U«.» hi
Adjust the mower ftrhile tractor is parked on
Jlíi^w^j f /ih f .» - Ijr^ I , ' “ . . j ' < 1 ^ O
-BA IÍ
el ground or
flated (See
“PRODUCT SPECIFiCATIONS” on page 2 of this manual).
if il|t- 1 '•Н ' “ Н ill I t ik I li ijl. 1 -s J-. i! ‘ill 11' .1 pil 1^ I- !Í If,, 'i¡Li .
your mower.
oiDt !U .- i ! i L Ali jU I r.'lt Co c,t^ i-igs. iy and ldj
® Rai .e liiotftei il - ti uh<-- nr*'itni<
« •^tihe (riidpoiiito both jid-cu1 Olí .wi t, measure height
from Dottoin edge of mowef íea'’*' I'to' E fei ¡nee “A” on
boih sides of mowe .should he fhr 'nme oi wiihin 1M'
c4 each other
• If adjustment is necessary, make adjustment on one
side of mower only.
• To raise one side of mower, tighten lift link adjustment
nut on that side.
• To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE: Three full turns of adjustment nut will change
mower height about 1/8".
• Recheck measurements after adjusting.
F
i l M t N I ( i
TBE LEVE
Í-TO-BAC
3 Piqs. 20 and 2
SIDE-TO-SiDE.
ADJUSiTMENT
ITH
FRONT LINI
LEVEL. SIDE-T
IMPORTANT: i
THE FOLLOWI
NECESSARY, BE SURE TO A[
EQUALLY SO MOWER WI
S!DE=
1' h‘-ii *1 i ‘ f Ll'it
. 1
- all -<-1 r i ami
shonldo^ < 1 -fhr titr ti' I hi r.; .T.aely 1 / 8 ' to
1' r II a at cha!, ih uar A l c f i i i - - r i ¡i i ,i», i i u i I it^. .t
position.
Che ' hr C .1 •ichl I i ■
f
!' a lui ‘tosur- d'S-
tanrr- i) flnr> iy intr'Kii i i n t ! -'tiin ' 'I k m a - i l * ' dtbnf[om
edge of n i n . / h ( , < , r g
• Before making any necessary adjustments, check that
both front links are equal in length. Both links should be
approximately 10-3/8".
• If links are not equal in length, adjust one link to same
length as other link.
• To lower front of mower loosen nut “E” on both front
links an equal number of turns.
• When distance “D” is 1/8" to 1/2" lower at front than
rear, tighten nuts “F” against trunnion on both front
links.
• To raise front of mower, loosen nut “F”from trunnion on
both front links. I ighten nut “E” on both front links an
equal number of turns.
• When distance “D” is 1/8" to 1/2" lower at front than
rear, tighten nut “F” against trunnion on both front links.
Ft-.. 2b