Recommended battery, Battery cables, Battery installation – Generac 0661-4 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BATTERY INSTALLATION
RECOMMENDED BATTERY
Install a battery that
meets the
following require
ments:
• Battery must be a 12 volt, automotive type storage bat
tery.
• For prevailing ambient temperatures above 32°F (0“C),
use a battery rated 70 amp-hours and capable of deliver
ing 360 cold cranking amperes.
• For prevailing ambient temperatures below
32°F
(0°C),
use a battery rated 95 amp-hours and capable of deliver
ing 450 cold cranking amperes.
IMPORTANT: IF THE BATTERY IS TO BE USED TO
POWER
OTHER
VEHICLE
ACCESSORIES,
AS
WELL
AS
START
THE
GENERATOR,
YOU
MAY
NEED A BATTERY WITH A LARGER CAPACITY.
BATTERY CABLES
Using battery cables that are too long or too small in
diameter may cause a drop in voltage which causes
starting problems. For best cold weather starting, the
voltage drop between battery terminals and the gen
erator connection point should not exceed 0.12 volts
per 100 amperes of cranking current.
Select battery cables based on (a) cable length, and
(b)
prevailing
ambient
temperatures.
Generally,
the
longer the cable and the colder the weather, the larg
er the cable size must be as shown in the chart
below.
CABLELENGTH
in Feet (meters)
CABLE SIZE
Oto 10 (Oto 3)
2*
11 to 15 (3.4 to 4.5)
0
16 to 20 (4.5 to 6)
000
‘For warm weather, use No. 2 cable up to 20 feet.
_
25
~