Trouble shooting chart – MTD 24665L User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLE SHOOTING CHART
1 PROBLEM
CAUSE
REMEDY
1. Engine fails to
to start.
A. Check fuel tank for gas.
B. Spark plug lead wire
disconnected.
C. Faulty spark plug.
A. Fill tank if empty.
B. Connect lead wire.
C. Spark should jump gap between control electrode and side
electrode. If spark does not jump, replace the spark plug.
2. Hard starting or
A. Spark plug wire loose.
A. Connect and tighten spark plug wire.
loss of power.
B. Dirty air cleaner.
B. Clean air cleaner as described in engine manual.
3. Engine over
heats.
A. Carburetor not adjusted
properly.
B. Air flow restricted.
C. Engine oil level low.
A. Adjust carburetor. See engine manual.
B. Remove blower housing on engine and clean as described in the
engine manual.
C. Fill crankcase with the proper oil.
4. Excessive
vibration.
A. Bent crankshaft.
B. Impeller assembly out
of balance.
A. Replace crankshaft (should be done by an authorized service
dealer).
B. Replace impeller assembly
NOTE: For repairs beyond the minor adjustments listed above, please contact your local authorized service dealer.
Hose Attachment Kit Model 294-210-000 and Blower Conversion Kit Model 294-211-000
are available as optional equipment.