MTD 24665L - Manual (Page 7)

12. Assemble the bag (E) by slipping the top straps
on the bag over upper handle. Hook the two
small straps over the stud pins on handle. See
figure 10.
13. Slip the elastic opening of the bag over the arr
duct assembly, making certain the elastic opening
is secured behind the flanges on all four sides of
on the air duct. See figure 11.
FIGURE 11
OPERATION
BEFORE STARTING
Service engine with gas and oil. See engine manual
packed with vacuum for complete instructions for
care and maintenance of engine. READ DIREC­
TIONS CAREFULLY.
A' CAUTION
Revolving Blades - Keep hands and
feet away from all openings.
) START ENGINE
After the engine has been properly fueled and oiled
(refer to engine operating and maintenance instruc­
tions), start engine as follows.
1. Move throttle control lever on engine to START
position.
2. Crank engine. Pull recoil with quick firm pull.
Do not pull out so far the rope stops with a jerk
as this will cause rope failure. Do not allow rope
and handle to snap back into place.
3. After two or three full firm pulls on recoil (or as
soon as engine fires), move speed control to RUN
position.
TO STOP ENGINE
1. To stop engine, move throttle control lever to
STOP position.
2. Disconnect spark plug wire and ground to prevent
accidental starting while equipment is unattended.
Operate a new engine at intermediate speeds and light
load for the first few hours as you would a new
automotive engine.