MTD 24665L - Manual (Page 5)

SPACER (L)
AXLE
SHAFT
FLAT
WASHER (M)
Slide spacers (L) onto the axle shafts. Place one
flat washer (M) on each shaft next to the spacers.
See figure 4.
FIGURE 4
.-s'
PUSH CAP (N)
Place rear wheels in position on the shafts, then
another flat washer (M). Secure with black push
cap (N) by placing the push cap in position and
tapping on with hammer or rubber mallet. See
figure 5.
FIGURE 5
UPPER HANDLE
8 .
HEX BOLTS (O)
HEX LOCK
NUTS(P)
LOWER HAND
Place the upper handle (C) in position over lower
handle. Fasten with four hex bolts (O) and hex
lock nuts (P) provided. See figure 6. Two
7/16" wrenches are required.
FIGURE 6