Assembly, Instructions, Contents of hardware pack: (see figure 1) – MTD 112-162A User Manual
Page 4: Note, Assembly instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
INSTRUCTIONS
FIGURE 1.
Lower
Handle
Inner
Hole
Outer
Hole
FIGURE 2
Weld Pin
NOTE
This unit is shipped WiTHOUT GAS-
OLiNE or OIL. After assembiy, see
operating section of this manual for
proper fuel and engine oil recom
mendations.
-Contents of Hardware Pack: (See Figure 1)
A (2) Hand Knobs
B (2) Curved Head Carriage Bolts
C (2) Hairpin Cotters
D (1) Hex Bolt 1/4-20 x 1.50" Long
E (1) Hex Lock Nut V4-20 Thread
F (2) Cable Ties
1. Remove lawn mower and all parts from the
carton. Make certain that all loose parts and
literature have been removed before the car
ton is discarded.
2. Extend throttle control which is attached to
the engine and place on the floor. Be careful
not to bend or kink control wire.
3. Fasten hole in lower handle over weld pins in
handle mount brackets on deck. Secure with
hairpin cotters (C) in inner hole on weld pin.
---- See figure 2.
FIGURE 3.
NOTE
There are two (2) holes in the handle
mount brackets. Place the hairpin
cotter in the inner hole for opera
tion. Outer hole is for storage.
NOTE
It may be necessary to pull open the
ends of the lower handle to obtain
a tight fit when assembled into
handle mount brackets.
There are two height positions for the handle.
Place upper handle in position over lower han
dle, selecting hole for either high or low posi
tion. See figure 8.
■Secure with two carriage bolts (B) and hand
knobs (A) as shown in figure 3. The knobs may
be assembled either to the inside or the out
side of the handle.