Repeat this step for the left pedal bracket (48) – NordicTrack E7SV NTEL07808.0 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Apply a small amount of the Included grease to
the right Crank Arm (20) and to a 19mm Wave
Washer (66).
Slide a Crank Arm Spacer (55) and the 19mm
Wave Washer (66) onto the right Crank Arm
(
20
) .
Identify the Right Roller Arm (59), which Is
marked with a “Right” sticker, and orient It as
shown.
Slide the Right Roller Arm (59) onto the right
Crank Arm (20). Attach the Right Roller Arm
with an M8
X
19mm Patch Screw (82), an Axle
Cover (53), and an M8 x 25mm Washer (98);
to
avoid breaking the Axie Cover, do not over
tighten the Patch Screw.
Repeat this step for the Left Roller Arm (not
shown).
5. Identify the Right Pedal Bracket (64), which Is
marked with a “Right” sticker.
Apply a small amount of grease to the Inside of
the tube on the Right Roller Arm (59) and to the
barrel of an M10 x 60mm Bolt (100).
Attach the Right Pedal Bracket (64) to the Right
Roller Arm (59) with the M10 x 60mm Bolt
(100), an M10 Washer (95), and an M10
Locknut (92).
Do not overtighten the Locknut;
the Right Pedai Bracket must pivot freely.
Repeat this step for the Left Pedal Bracket
(48).