Transfer switch isolation method, Figure 2.19, Installation with isolation receptacle – Generac 02010-1 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 2 - Installation
INSTALLATION
PRIMEPACT so Recreational Vehicle Generator
2.7.6
POWER SUPPLY
CORD___________________
The power supply cord must comply with all applic
able codes, standards and regulations. It must be
large enough to handle the full amperage to which it
will be subjected.
♦ 2.7.7 GROUND FAULT CIRCUIT INTERRUPTERS
The National Electrical Code (NFPA 70, 551-7)
requires that you install ground fault circuit inter
rupters (GFCIs) on all external and some internal
electrical receptacles. Contact your manufacturer or
dealer for recommendations.
Figure 2.18
-
Transfer Switch Isolation Method
FROM 20
AMP
HACR BREAKER
2ND AIR
CONDITIONER
VEHICLE AC
DISTRIBUTION
PANEL
30 AMP
MAIN BREAKER
HACR
BREAKERS
FOR AIR
CONDITIONERS
GFCI
BREAKERS
POWER SUPPLY CORD
Figure 2.19
-
Installation With Isolation Receptacle
DOCKSIDE
POWER
RECEPTACLE
POWER
SUPPLY
CORD
Qenerac® Power Systems, Inc. 33