Tine assemblies, Before starting engine, Starter hand figure 12 – MTD 213-381A User Manual

Page 7: To start engine, Operation

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Disconnect the spark plug wire from spark

plug to prevent accidental starting. Secure

end of spark plug wire in the “V” slot on the

----- engine. See figure 10. With the clutch lever in

neutral position, pull starter cord several

times. The tines should not turn. If they do,

remove the hairpin cotter and remove the con

trol rod from the clutch lever. Thread the con
trol rod in or out of the ferrule as necessary.

Replace and check again for correct adjust
ment.

FIGURE 10.

TINE ASSEMBLIES

Check to be certain the tine assemblies are on the
tine shaft so that the sharp edge enters the soil

■first. See figure 11.

FIGURE 11.

OPERATION

BEFORE STARTING ENGINE:

1. Before starting, fill crankcase with oil as in

structed

the

separate

engine

manual

packed with the unit.

2. Fill fuel tank with clean, fresh, lead-free, low-

lead, or regular grade leaded gasoline.

Starter Hand

FIGURE 12

idle

TO START ENGINE:

CAUTION

BE SURE NO ONE IS STANDING IN
FRONT OF THE TILLER WHILE THE
ENGINE IS RUNNING OR BEING

STARTED.

1. Place the shift lever in the neutral (N) position.

See figure 13.

FIGURE 13.