MTD 213-381A - Manual (Page 6)

Screwdriver
Self-Tapping
Screw (C)
THROTTLE CONTROL INSTALLATION
1. Place the throttle control up through the slot
in the handle panel. Secure with two self­
tapping screws (C). Tighten securely with a
------ screwdriver. See figure 7.
FIGURE 7.
2. Place the throttle control knob (L) over throttle
control lever. Tap on with a hammer. See
—figure 8.
3. Secure throttle control cable to handle with
cable ties (N). Cut off excess ends.
FIGURE 8.
Hairpin Cotter (J)
Clutch
Rod
Idler
Bracket
Ferrule^
CLUTCH CONTROL ROD INSTALLATION
1. Place shift lever (located on handle panel) in
neutral (N) position. Place bent end of control
rod into shift lever. Secure with hairpin cotter
------ (J). See figure 9.
2. Thread ferrule (H) onto the other end of con­
trol rod so that the ferrule lines up with the
hole in idler bracket. Secure with cotter pin (I).
See figure 9.
FIGURE 9.