MTD 213-381A - Manual (Page 5)

Depth Bar
Spring
Pin (M)
DEPTH BAR INSTALLATION
Slide the depth bar into the tailpiece to desired
-depth. Secure with clevis pin (K) and spring pin
(M). See figure 4.
FIGURE 4.
FIGURE 5.
HANDLE ASSEMBLY
1. Secure handie panel to handles by placing
carriage bolts (P) through the lower holes in
the handle panel and through the handles.
Secure with lock washers (Q) and hex nuts (R),
finger tight only.
2.-Remove hex bolt and belleville washer from
------each side of frame as shown in figure 5.
3.
4.
5.
6
.
Place the handle panel assembly in position
against the frame.
Start the hex boit and beiievilie washer (re­
moved in step 1) by hand in the bottom hole in
handie. See figure 6.
Select height position for the handie by lining
up one of the holes in the handle with desired
hole in frame. See figure 5.
FIGURE 6.
Place belleville washer (E) on hex bolt (D), and
insert hex bolt through handle and frame.
Secure with iock washer (F) and hex nut (G) on
—inside of frame. See figure 6.
7. Tighten all nuts and bolts securely.
NOTE
The clutch rod must be readjusted
whenever the handle height is
changed.
8. Slip hand grips on the upper end of each han­
dle. They will slip on more easily If you first
soak them in warm soapy water.