beautypg.com

NordicTrack NTC59020 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

2. While another person lifts the rear of the Frame (1),

attach the Rear Stabilizer (16) to the Frame with four

M8 X 40mm Button Screws (54) and four M8 Split

Washers (55).

3. While another person holds the Upright (2) in the posi­

tion shown, connect the Upper Wire Harness (42) to
the Lower Wire Harness (43).

Carefully pull the

upper end of the Upper Wire Harness to remove
the slack from the Wire Harnesses.

Make sure that the Upright (2) is turned so the top

siopes down in the direction shown.

Slide the

Upright onto the Frame (1).

Be careful to avoid pinch­

ing the Wire Harnesses (42, 43).

Attach the Upright to

the Frame with four M8 x 40mm Button Screws (54)
and four M8 Split Washers (55).

4. Hold the Handlebar (3) near the Upright (2). Feed the

Upper Wire Harness (42) up through the indicated hole
in the Handlebar. Attach the Handlebar to the Upright

with two M8

X

25mm Patch Screws (59) and two M8

Split Washers (55).

Be careful to avoid pinching the

Upper Wire Harness.