Drive belt, Discharge chute deflector, Transport – Ariens SNO-THRO 008-SS322E User Manual
Page 20: Storage, Engine trouble shooting, Accessories, Drive belt discharge chute deflector, Storage accessories
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

D
rive
B
elt
To replace drive belt (Figure 13):
1. Remove Cowl and disconnect Extension Spring on
Idler Arm/Brake.
2. Remove Cap Screw and Washer from end of
Impeller Shaft and pull off Impeller Drive Pulley.
Remove old Belt and install new one.
3.
4.
Replace parts in reverse order checking to be sure
there is 1/32 to 1/16“ (1-1.6 mm) clearance
between Belt Finger and back side of Belt with
Impeller Clutch Bail engaged.
D
ischarge
C
hute
D
eflector
If Discharge Chute Deflector does not stay in set position
during operation adjust chute by:
• Tightening Fasteners evenly until Deflector stays in
position (Figure 14).
NOTE:
Use a #T30 Torx Drive or a 3/16" (.19 cm) wide
Straight Screwdriver to tighten.
T
ransport
Equipment should be shut off when transporting. To
transport equipment to or from an area to be cleared,
press down on handlebar enough to raise front of Sno-
Thro slightly off surface and push or pull unit.
S
torage
Run the unit with Impeller Clutch engaged a few minutes
after each use to free unit of any loose or melting snow.
Keep all nuts, bolts and screws tight and be sure unit is
in safe working condition. Check all hardware at regular
intervals.
Never store unit with fuel in tank inside a building where
fumes may reach an open flame or spark.
Allow engine to cool before storage in any enclosure.
Be sure to drain fuel or run the fuel tank dry before
storage.
It is possible to hang the unit on a wall.
E
ngine
trouble
shooting
PROBLEM
Probable Cause
Engine will not crank
Check if Key Switch is in run position
Check for a bad starter or connections.
Check for electrical problems.
Engine will not start
Check for electrical problems.
Check for engine ignition problems - see Engine
Manufactures Service Manual.
Engine stops.
Check fuel supply. Use only clean fuel.
Check spark.
Engine power, noise, idle and shut down.
See Engine Manufactures Service Manual.
A
ccessories
737001
Electric Start (3 HP)
737002
Electric Start (3 HP)-Canada
738001 Electric Start (5HP)
16
Ariens® Sno-Thro® Orig. 4/96