Operation, Standard controls, Impeller – Ariens SNO-THRO 008-SS322E User Manual
Page 14: Impeller clutch bail, Choke control knob, Recoil starter handle, Ignition switch, Impeller impeller clutch bail ignition switch, Choke control knob recoil starter handle
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
<
t
4
SECTION 4: OPERATION
C
ontents
• Standard Controls
• Pre-Start
• Starting and Shut Off
• Controls and Features
' Throwing Snow
Operation
S
tandard
C
ontrols
See Figure 9 for Control and Feature locations.
Impeller
During snow removal, Impeller propels unit forward while
collecting snow. Forward speed will vary according to
snow depth and moisture content.
Impeller Clutch Bail
Squeeze Impeller Clutch Bail against
Handlebar to engage Impeller. Unit will
move fonward and throw snow. Release
Bail to disengage and brake Impeller
Choke Control Knob
When pulled out (away from Impeller
Housing), Choke Control Knob chokes off
air to engine for easier start. When pushed
in. Control Knob allows for normal
operation.
IMPORTANT:
ALWAYS push Control Knob in (towards
Impeller Housing) after engine start.
Recoil Starter Handle
When pulied. Recoil Starter Handle will turn engine over.
IMPORTANT:
Check impeiler to be sure it
is not frozen. If belt squeals when Clutch
Bail is engaged. Impeller is frozen.
Release Clutch Bail and move equipment
to a heated area to thaw.
IMPORTANT:
Check Clutch/Brake
function before each use. If Impeller does
not stop quickly when Impeller Clutch Bail
is released or there is no noticeable
increase in Bail force before contacting
Handlebar, adjust as directed in
Maintenance Section, or repair before
operating unit.
Ignition Switch
See Figures 7 and 8.
Ignition Switch is operated by a removable Key. It has
two positions:
^ "Stop" Position
(2) Run Position
Primer Bulb
Push Primer Bulb in to add fuel for easier
engine start (Figure 8).
10
Ariens® Sno-Thro® Orig. 4/96