beautypg.com

Dealer preparation for operation, Steering wheel, Seat – Ariens 912 User Manual

Page 6: Engine, Tire pressure, Wheel brakes

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Dealer Preparation for Operation

Customer Note: Your Ariens Dealer is expected
to complete these preparation steps and
review important information, including this
manual, with you before or upon delivery of
this unit.

The preparation information is included here

so that you and your dealer may review it
together.

NOTE: All references to “Left”, “Right”,
“Front” and “Rear” are given from operator’s
position.

Steering Wheel

Lubricate column shaft and place steering
wheel onto it; with holes lined up, drive the V4

X 1-3/4” roll pin through holes to secure. (Pin
should have equal spacing on both sides of
steering wheei base.)

1. Steering Wheel

2

.

3.
4.
5.

6

.

7.

1/4 X 1-3/4” Roll Pin

3/16 X I” Roll Pin
Wesher
Wave Washer
Flanged Bushing
Column Shaft

8. Steering Pinion

Figure 2: Steering Wheel and Shaft

Place washer, wave washer and flanged
bushing on column shaft and column shaft in-
to steering column. Position bottom end of
shaft on steering pinion, line up holes and
secure with two 3/16 X 1” roll pins.

Trap washer, wave wa:sherand flanged bushing
on top of column by%iving the 3/16 XI” roll

pin through hole in column shaft above

washer,

Install plug on right hand side of steering

column.

Seat

Place seat on seat bracket and install cap

screw, lock washer and seat support washer.
Connect seat switch wires to connectors.
Slide seat to a safe comfortable operating

position and tighten cap screw to secure seat

in position.

Engine

IMPORTANT; Engine is shipped without oil in
crankcase. Refer to instructions in Lubrication

and Maintenance Section to fill.

Battery

(electric start models)

Battery is shipped without electrolyte. After
removing battery from tractor, fill each ceil

with electrolyte to level indicator. Instructions
for battery removal and charging are in

Lubrication and Maintenance section of this
manual.

Tire Pressure

Riding movver was shipped with tires over in-

fiated to ensure seating of bead. Reduce tire
pressure to 12 PSI before operating unit.

Wheel Brakes

Wheel brakes are properly adjusted at factory.
Test brakes after riding mower Is assembled to

be sure adjustment has not been disturbed in

shipment. Refer to Adjustments Section of
this manual.