MTD 217-310-000 - Manual (Page 7)

11. Place the handle panel (AB) in position on the
handles. Secure the upper holes in the panel to
the handles with carriage bolts (A), lock washers
------ (B) and hex nuts (C), finger tight only. See figure
10 .
12. Place carriage bolt (A) through the handle panel,
handle and handle brace on the lower right hand
side of the handle panel, finger tight only. See
figure 10.
13. Place carriage bolt (A) through the handle panel,
handle, handle brace and cable support bracket
on the lower left hand side of handle panel as
shown in figure 11. Use the bottom hole in the
cable support bracket. Secure with lock washer
and hex nut, finger tight only.
FIGURE 11.
14. Place flat washer (I) between handle and upper
hole on cable support bracket. Secure with hex
------ washer head self-tapping screw (J). See figure 12.
15. Now tighten securely the self-tapping screw and
all nuts and bolts on handles and braces.