Clarion CZ509 - Manual (Page 11)

English
11
CZ509
6. OPERATIONS
Note:
• Be sure to read this chapter referring to the front diagrams of chapter “3. CONTROLS” on page 6.
Basic Operations
CAUTION
Be sure to lower the volume before
switching off the unit power or the ignition
key. The unit remembers its last volume
setting.
Turning on/off the power
Note:
1. Press the [SRC] button to turn on the power.
2. Press and hold the [SRC] button (1 sec.) to
turn off the power for the unit.
Note:
• System check
The first time this unit is turned on after the wire
connections are completed, it must be checked
what equipment is connected. When the power
is turned on, the “SYSTEM CHECK” appears in
the display, then the unit returns to the clock
display mode. The system check starts within the
unit. Then press the [SRC] button again, the unit
turn to the radio mode.
Selecting a mode
1. Press the [SRC] button to change the
operation mode.
2. Each time you press the [SRC] button, the
operation mode changes in the following
order:
Radio ➜ (Satellite radio) ➜ CD/MP3/WMA/
AAC ➜ USB/MTP/iPod ➜ BLUETOOTH ➜
(CD changer) ➜ AUX ➜ Radio...
∗ External equipment not connected with
CeNET is not displayed.
∗ iPod/MTP can connect to this unit via USB
cable.
Adjusting the volume
1. Turning the [ROTARY] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
∗ The volume level is from 0 (minimum) to 33
(maximum).
Switching the display
Press the [DISP] button to select the desired
display.
Sound Adjustment
You can adjust a sound effect or tone quality to
your preference.
● Setting the BEAT EQ
This unit is provided with 4 types of sound tone
effects stored in memory.
Select the one you prefer.
∗ The factory default setting is “OFF”.
2-1. Select “BEAT EQ” .
To change sound setting
1. Press the [SOUND] button to switch to the
sound adjustment selection display.
∗ The factory default sound setting is “BEAT
EQ”.
2. Then press the [
x] or [v] button to
select the sound adjustment mode.
Each time you press the [
x] or [v]
button, the sound adjustment mode
changes as following order:
“BEAT EQ”
↔ “M-B EX” ↔ “BALANCE” ↔
“FADER” ↔ “LPF” ↔ “S-W VOL” ↔ “HPF”
∗ In the case of display blinking “ENT”, you
can press the [ ] button to adjust the
setting value.
3. Press the [ ] or [ ] button to adjust the
selected audio mode.
4. After completing settings, press the
[SOUND] button to return to the previous
mode.
CZ509_ENG.book Page 11 Tuesday, January 13, 2009 10:20 AM