Warning, Pre-starting, Instructions – Troy-Bilt 13027 User Manual
Page 18: Figure 4-1, Pre-starting instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Section
Steering Wheel
Brake Pedal
Choke Lever / //) Fuel
Cap
Throttle Lever
Light
Switch
Cruise Control
Switch (Optional)
Figure 4-1
Hour Meter (Optional)
Keyswitch
Electric Lift
(Optional)
Choke ■ FTO Indicator volt Light
Leygj
Light
^
Light
Indicator Light
Lever
WARNING
Before operating your tractor,
be sure you read and under
stand all safety, controls, and
operation instructions in this
Owner/Operator Manual and
on the decals on your tractor.
Failure to follow these in
structions can result in seri
ous personal injury or prop
erty damage.
PRE-STARTING
INSTRUCTIONS
Please read and carry out the
following pre-starting instructions
and procedures before starting the
tractor engine and using your
equipment.
1. Be sure the engine has been
filled with the proper type and
amount of motor oil. Check the
oil level by removing the engine
dipstick on top of the engine (see
Assembly Step 8 in Section 2).
2. Check for any oil or fluid leaks
on the tractor or on the ground.
18
Any leaks must be attended to be
fore starting your equipment. See
your Authorized Dealer for assis
tance if needed.
3. Check the battery electrolyte
level. Fill any cells that are below
the full mark with distilled water.
4. Fill the fuel tank with fresh,
clean unleaded gasoline. Auto-
motive-grade Unleaded Regular
gasoline with an octane rating of
87 minimum is highly recom
mended. Clean up any spills. DO
NOT MIX MOTOR OIL WITH
THE GASOLINE!