SINGER W1411 - Manual (Page 30)

1. Set the pattern selector at " B Then pass the needle thread
through the opening in the buttonhole foot and draw both needle and
bobbin threads to the left side. Turn the balance wheel towards you
until the needle comes to the point (1).
2. Lower the foot and sew slowly until a desired length is sewn,
then stop the machine at (2).
3. Raise the needle and set the selector at " O Then sew
several stitches of bar tack until the needle is at point (3).
4. Raise the needle and set the selector at " I3 ", then sew the
right side of buttonhole just as the same length as the left side
of buttonhole. Stop the machine at (4).
5. Raise needle and set the selector at " [H ", then sew several
stitches of final bar tack. Stop the machine with the needle
at point (5). To lock threads, set the pattern selector at "B
(zero point of zigzag width)" and sew a few stitches.
6. Cut the buttonhole open carefully using a seam ripper, taking
care not to damage the bar tacks.
Note: "To make a heavier buttonhole, sew twice by repeating the
same procedure.
SEWING BUTTONHOLES (continued)
1 .
c
]