SINGER W1044 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. THREADING THE MACHINE
Place a spool of thread on spool pin and raise the take-up
lever to its highest point Refer toiFig. 8).
Pull thread through slot of upper thread guide (1) down
through tension discus(2)up into thread check spring (3) and
(4) and on up into the eye of the take-up lever (5) from right
to left.
Return thread through middle thread (6) down through lower
guide (7) and into needle bar thread guide (8).
Thread needle from left to right, pulling about four inches
of thread through needle.
7. SETTING THE NEEDLE
1. Turn the balance wheel towards you, raising needle bar
to its highest position, and loosen the needle clamp screw.
2. Hold the needle in the left hand with the point down
and insert the needle up into the needle clamp as for
as it will go with its flat surface to the right then retight
en the clamp screw {Fig. 9).