Placing bobbin case in shuttle, Upper threading (fig. 10) – SINGER W7911 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

PLACING BOBBIN
CASE IN SHUTTLE

Raise needle bar to high

est position, and lift hing
ed

cover

plate.

(See

10,

10, Fig. 1.) Hold the bob
bin case latch, (D), Fig. 9,
between

the

thumb

and

forefinger of the left hand,
with

least

three

inches

of thread running from the top of the bobbin case
to

the right.

Insert and

center the

bobbin case on

the stud of the shuttle body, (C). Be sure the bob

bin

case

finger,

(E),

opposite

the

shuttle

race

notch,

(A).

Press

the

bobbin

case

(B)

into

the

shuttle as far as possible until latch catches on the
center post of the shuttle. THEN release the bobbin

case latch, (D). Press bobbin case again after latch
has been released to make sure the bobbin case is
locked securely in place. Close the cover plate.

UPPER THREADING (Fig. 10)

1) Place spool of thread on spool pin nearer the

needle.

2) Lead thread through upper thread guide A on

back of face plate.

3) Down and around tension discs B from back to

front

Fig. ID