SINGER 177 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

3. Place bobbin on spindle and slide bobbin

and spindle to the right.

4. Hold thread end and start the machine.

(Thread end will break off after a few coils

have been wound.)

5. When bobbin is slightly less than full, stop

the machine and slide bobbin and spindle

to the left. Cut thread about four inches from

the bobbin and remove bobbin from spindle.

6. Hold the hand wheel from turning and tighten

hand wheel knob.

The bobbin-winding tension has been pre-set

at the factory and should need no adjusting.

However, if adjustment is required, loosen the

screw that holds the bobbin-winder tension

bracket to the machine and slide the bracket

forward if bobbin winds high to the rear; slide

bracket back if bobbin winds high to the front.

Winding steps (continued)