Belt adjustment, Replacin8 needle, M]mm – SINGER W130 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fia. 4
2. BELT ADJUSTMENT
Loosen motor bracket screw (A).
Slide motor bracket down to tighten
- up to loosen.
CAUTION : Do not tighten belt
too tight.
3. REPLACIN8 NEEDLE
1. Raise the needle bar to its highest
position. (Turn the fly wheel by
hand toward you.)
2. Loosen needle clamp screw (A) and
remove old needle.
3. Insert the needle into needle bar (B)
with the flat side of the needle toward
the fly wheel.
C.AUTION ; Be sure the needle is
all the way up. It should rest against
the needle stop pin (C).
4. Tighten the needle clamp screw se
curely with screw driver.
C.AUTION ; Check needle and make
sure it is not bent or dull.
4
.
m]mm
b ob b i n
c a s e
Raise ihe needle bar to its highest
position. (Turn the fly wheel toward
you b}' hand.)
Open slide plate. With the left
thumb and forefinger, open the latch
(A) of the bobbin case (B).
Remove bobbin case from the spindle
post (C). (Pull to the left.)
NOTE : With the latch held open,'
the biihbin is locked inside the
bobbin case. To remove bobbin from
the bobbin case, release the latch.