SINGER W130 - Manual (Page 18)

•3 i
18. OILING THE MACHINE
As is the case with all precision
machinery, it is necessary for maxi­
mum efficiency to properly oil and
clean at reasonable intervals. Even
though the machine is not in con­
stant use, it is important to oil your ^
machine since the oil will dry after
standing over a period of time.
The underside of the machine should
be oiled at the arrow points as shown in
Fig. 48.
NOTE ; Before oiling, clean away all
lint or foreign matter. One or two
drops are sufficient at each point.
The machine should be oiled at the
arrow points as shown in Fig. 49. These
parts are accessible by opening the face
plate.
To oil the top parts of your machine,
remove the two screws (A & B) located
at each end of the top cover (C). Remove
top cover and oil the parts located at the
arrow points as in Fig. 50.
NOTE' : After you have cleaned and
oiled your machine, it is advisable to
run the machine at high speed so that
the oil will penetrate all moving parts.
CAUTION : After cleaning and oiling
machine, wipe away all excess oil, and
sew on waste material.
18. B U I L T I N L I G H T
Your machine is equipped with a built
in sewing light, located inside the face plate.
NOTE : Face plate is hinged (See
Fig. 51) and' opens from left to right.
The sewing light switch is located on
the front of the face plate (See Page 1).
The sewing light is a standard bulb and
can be easily replaced.
Fis. 49
• •
Fig. 50
16
Fig. 51