Four-step buttonholes (cont’d.) – SINGER 484.1544180 (Sold at Sears) User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Four-Step Buttonholes (Cont’d.)
A B C D
B
C
D
t
Step C: Front Bartack
* Raise needle out of fabric.
* Turn stitch-length dial to “C”.
^
Sew four stitches ending at point (1).
Step D: Left Side Stitching
* Raise needle out of fabric.
* Turn stitch-length dial to “D”.
^
Sew side stitching until it meets rear bariack
at (2). The buttonhole is now complete.
Changing Stitch Density
To obtain a similar stitch density on both sides
of the buttonhole, the balance control may need
adjustment as follows:
* With balance control centered, make a test
buttonhole.
* If stitches on right side are too far apart,
move control downward.
* If stitches on right side are too close, move
control upward.
Re-center control after all buttonhole sewing is
complete.
25