R-cv;t3 rsp^£c3 r.ssd^ss, To remove the needles, To replace the needle – SINGER 14U64A User Manual
Page 23: Hcv; to rsplccs st£t:oo£ry koifs, How to exchange light bulb, R-cv;t, Rsp^£c, R.ssd^ss, How to exchange light, Bulb
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
13
. r-cv;t
3
rsp^£C
3
r.ssd^ss
Use Singer needles Cat. No. 2045 avaiiable in sizes #I 1 and #14.
To remove the needles:
® Be sure the power line plug is disconnected from the wall receptacle.
» Turn the hand wheel toward you until the needle is at its highest
position. Loosen the needle set screw with a screwdriver and remove
needles.
To replace the needle:
0 Insert the needles into the needle bar hole as far as they will go with
flat surface to the rear and securely tighten the needle set screw.
14
. Hcv; to rsplccs st£t:oo£ry koifs
The stationary knife should be changed when it becomes dull.
The stationary knife can be replaced according to the following steps, however if them are any difficulties
experienced, call your Singer representative to make the adjustment.
(1) Be sure that the power line plug is disconnected from
the wall receptacle.
(2) Open the looper cover and set the movable knife in the
non-operating position (see page 12).
(3) Loosen the stationary knife set screw and remove the
stationary knife.
(4) Place a new stationary knife in the groove of the
stationary knife holder, align the cutting edge level
with the top surface of the throat plate and tighten set
screw.
(5) Return the miOvable knife to its original position.
15. How to exchange
light
bulb
First of all, be sure to disconnect power-line plug.
Remove light cover as shown in figure, turn bulb to left and
remove. To replace, push bulb into socket and turn to right.
Light bulb is a bayonet type and be sure to purchase a
12 volt, 6 watt bulb when replacing.