SINGER W1266 - Manual (Page 6)

/ 1 , 3
^^■=
9515
*
Fig. 3
Fig. 4
WINDING THE BOBBIN
yo„°rc”„''u^Lr'‘otciw!si.'^ ^ by turning clutch 6 toward
“Slide latch 4 to the right (Fig. 4) to spring open cover 3 of the recessed winder”
Place a yool of thread on one of the spool pins, lead thread through the upper thread guide
on arm and down through terision disc 14 Fig. 5 at base of machine. Run end of thread throuS
a hole in bobbin edge < left flange and from inside out) and place bobbin B on spindle of bobbin
winder 7 Fig. 4 fitting the notch bobbin
over small pm on Spindle. Push bobbin
winder against hand wheel. Hold thread
end loosely and start machine slowly
Bobbin will stop winding when it is
filled. Turn clutch away from you until
sewing mechanism is again engaged so
that needle moves when you turn the
hand wheel.
Break off loose thread end used to
start the winding and thread bobbin as
stated on Page 6.