SINGER W1266 User Manual

Page 38

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

B I N D E R

This attachment folds bias binding, applies it to the edge of material in one operation. Slots

on scroll of the binder are for corresponding widths of commercial folded bias binding.

The open mouth of binder scroll is used for unfolded bias strips cut 15/16 inch wide.

FOLDED BINDING (Fig. 69)

Cut a point on folded binding, insert in appropriate

slot. Draw through slot and under binder with strong
pin. Test stitching to be sure it is on the edge. Adjust
by sliding binder to right or left.

TWO-TONE BINDING (Fig. 70)

Two bindings can be sewn on fabric edge also in one

operation. When two are used, always skip one size be
tween widths, inserting each in correct size slot.

HAND-CUT BIAS BINDING

(Fig. 69^

Cut 15 16 inch bias binding fold in half for a couple

of inches. Cut binding diagonally toward end, almost to
fold. Slip fold into center of binder. Draw back until
cut opens and binding encircles open end of scroll. Test
stitching

t o

be sure it is on the edge adjust if necessary.

See Fig. 67

and

for

suggestions
on how to use
the

binder.

There

are

hundreds

other uses.

Fig- 68

Fig, 70