Procedure – SINGER W511 User Manual

Page 29

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Button Foot

Other Applications

Needle Position Selector and

Zigzag Width Control Dial

PROCEDURE:

•

Set drop feed button "Si" position with the needle position selector

" 1" position.

• Place button under button foot such that the needle is aligned

directly with the left hole in your button. Check alignment by
turning hand wheel and watching needle.

• Bring the needle slightly above the button and turn stitch width

knob until needle aligns with the right hole in the button.

• Run machine slowly and make 7-8 stitches.

• With needle in left hole return zigzag width knob to the "0"

position and make 3—4 stitches to tie off your button.

•

Apply the above method to sewing on buttons with four holes, hooKs,

snaps, etc.