SINGER 15-90 User Manual
Page 62
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To Pipe a Ruffle:
60
Cl)
Insert the material to be ruffled between the two
blue blades Line 3, Fig. 67. This material must
not exceed inches in width.
F
ig
. 67. C
orrect
P
ositions
for
the
M
aterials
(2) The piping material is usually cut on the bias and
it should be about 34 inch wide when folded in
the center. Place the piping material in the
ruffler, following Line 5, Fig. 67 with the folded
edge of the piping to the right.
F
ig
. 68. P
iping
a
R
uffle
(3) Fold the edge of the material to which the piping
and ruffling are to be attached and insert it in
the rufffer, following Line 6, Fig. 67.