SINGER 14U22 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(2) Thread left looper in sequence from (a) to ® (marked in yellow color). Cylinder cover must also be
removed when threading this part. (Refer to page 5 for cylinder cover removal).
Wind thread around
thread guide when
threading
(g)
as
shown in figure.
Tension discs
While holding thread with finger,
pass it between the tension discs
and pull thread down to make
certain it is properly located in
between the tension discs.
Turn machine pulley toward you
until left looper is at left as far
as it will go and thread looper
thread hole (g) from left to
right. (Use tweezers provided in
your accessory set).
Turn machine pulley toward you
until the looper is at right as far
as it will go passing the thread
under the throat plate, then
using a tweezer, thread the
looper thread hole ©from front
to back. Draw about 5cm (2
inches) of thread from thread
hole.