SINGER 7106 - Manual (Page 27)

SELECTING A PATTERN GROUP
Before moving pattern group selector, make
sure needle is above fabric.
When you rotate the pattern group selector,
one of six different groups of stitch pattern is
available to you.
Slide stitch width selector to i , then rotate
the pattern group selector as required, until
the number of the desired group of two stitches
is positioned under the T symbol above the
selector.
ADJUSTING STITCH PLACEMENT
Before moving needle position selector, make
sure needle is above fabric.
All stitch patterns can be sewn In either left
J* , centre JL , or right J, needle position
Selector setting centre X is used most often.
A L left or J, right setting is used to
place narrow stitch patterns to the left or right
of the centre in decorative work.
ADJUSTING STITCH LENGTH
When you are preparing to do pattern stitch­
ing, make a test sample with the fabric and
thread you plan to use so that you can adjust
the stitch length correctly.
Any sitch length setting from 1 to 4 will give
you an open stitch pattern of whichever de­
corative stitch pattern you select. The higher
the number, the more open, or farther apart,
your stitch will be. The area between 0 and 1
of the selector is used for the fine adjust­
ment of satin stitching (see page 21).
For stretch stitch patterns, stitch length is
controlled with a single setting of the stitch
length selector. Simply rotate it until the co­
loured bar I is under the ▼ symbol above
the dial.
ijilllllllll
'i-i- it:.'; :
: ::: <
2 3 'W H
Setting for Stretch StHch Pattern
25