SINGER W1514 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CLEANING AND OILING THE SHUTTLE
The
stitch
forming
mechanism
occasionally
becomes clogged with loose threads and lint.
This
will
interfere
with
the
efficient
operation
of the machine. Cleaning and removal of the
lint will safeguard the performance. To remove
shuttle:
1. Turn the balance wheel until the needle
reaches
its
highest
position.
Tilt
head
back on its hinges.
Remove bobbin case (Ä), Fig. 21.
Turn shuttle race cover clamps B down
ward and pull hinged shuttle race cover,
C, down and remove shuttle D.
Clean
the
shuttle
race,
the
shuttle,
and
shuttle race cover by removing all threads,'
lint, etc.
Apply a drop of oil with finger tip to
Pig.
21
outer edge of shuttle.
When the cleamng has been completed, proceed as follows to replac# Üie shuttle assembly ;
. lum the balance wheel until the needle reaches its highest position.
.
shuttle JD, Fig. 21, agamst shuttle driver and adjust iatol position.
position by turning clamps B upward
A.
p
hinge bracket, replace with polished side out.
4.
Fut
bobbin into bobbin case
A.
5.
Put the bobbin case into shuttle race, fitting tongue into
notch E
of race cover.
_ 17 _
2.
3.
4.
5.
■ÖfaiF: